Have a different error code? If your lights are flashing alternately (one then the other), that is a paper feed jam. If they are flashing together (sync), that is the waste ink counter. Reset wisely.
Save the printer. Just check the sponge every year.
Open the printer. Remove the left side cover. You will see a white plastic cartridge with a sponge. Take it out, squeeze the ink into a trash bag (wear gloves—it’s toxic), and let it dry. Or replace it with a new generic pad for $3. Why the T10/T11 Specifically? The Epson Stylus T10 and T11 are unique because they use the DURABrite Ultra pigment ink. Pigment ink clogs waste pads faster than dye ink. Epson knew this, so they set the counter aggressively low—often triggering at just 30% of the pad's physical capacity.
The official solution? Replace the sponge and pay Epson $100 for a mainboard reset. Epson Stylus T10 T11 Working Resetter
There are dozens of fake “Resetter.exe” files online that contain malware. We will get to the safe method below. Deep Dive: The Protocol The T10 and T11 use a variant of the ESC/P-R raster protocol. When the printer is in "Service Required" mode (flashing ink and paper lights simultaneously), it rejects standard print commands. However, it remains listening on USB for specific Reverse Engineering Transfer (RRT) commands.
Epson programmed a inside the printer’s EEPROM. When that counter hits a specific number (usually around 15,000 to 20,000 pages or 50 power cleanings), the printer hard-locks itself.
Let me save you $50 and a trip to the repair shop: The Ink Pad Lie (And Why Epson Stops You) Here is the technical reality most people don’t know: Your Epson Stylus T10/T11 has a “Waste Ink Pad” (also called the Ink Absorber). Every time you clean the print head, a small amount of ink is pumped into a sponge at the bottom of the chassis. Have a different error code
Resetting these models is actually safer than resetting a dye-based model, because the pigment ink dries into a solid chunk rather than leaking as a liquid. The Epson Stylus T10/T11 Working Resetter is not a hack. It is a recovery tool . Epson puts this software in their service manuals (not for public release). Using it returns your printer to the exact state it was in the day you bought it—full sponge and all.
When you reset the counter, you are tricking the printer into thinking the sponge is empty. But the sponge is a physical object.
If your printer was flashing the error after 2 years of use, you are probably fine. There is a lot of empty space in that chassis. Reset wisely
If you are reading this, you have likely just been greeted by the dreaded alternating flashing lights on your Epson Stylus T10 or T11. The printer refuses to move. The head is locked. And Windows is screaming “A printer service required.”
This software speaks directly to the printer’s maintenance port (not the standard print driver port). It bypasses the normal queue and reads the counters. More importantly, it writes zeros back to the "Protection Counter."
The real solution? The . What is the “Resetter”? The “Epson Stylus T10/T11 Resetter” is a misnomer. It isn't a physical dongle (usually). It is a piece of proprietary Windows software called the Adjustment Program (AdjProg) .
If your printer was flashing the error after 8 years of heavy use, you have a ticking time bomb. The ink will eventually leak out of the bottom of the printer, ruining your desk and potentially shorting the power supply.