Who commands this switch? A tiny 8-pin chip: the . In most S-60-12 units, it’s a UC3842 or KA3842 (a current-mode PWM controller). Manish found the chip near the optocoupler.
In a cramped, sun-drenched workshop on the edge of the city, old Manish had a rule: “Never throw away a power supply. Its heart may still beat.”
“You see?” he told his young apprentice. “Every component tells a story. The S-60-12 is not just a power supply. It’s a translation—from the raw, chaotic energy of the grid to the peaceful, precise language of electronics.” s-60-12 power supply circuit diagram
He connected an old LED strip. It blazed to life.
“This is the etiquette section,” Manish chuckled. “The power supply says, ‘I will take your energy, but I won’t pollute the radio spectrum.’” Next came the bridge rectifier —a black, square, four-pin component (often a KBL406 or similar). It takes the 120V or 230V AC sine wave and flips the negative humps upward, creating a pulsating DC voltage. Manish scoped it: a bumpy 120Hz waveform (if in North America) or 100Hz (in Europe). Who commands this switch
That wild, bumpy DC needs smoothing. And here stood the giant: the (C5, usually 100-150µF, 200V for 110V regions; or 68-82µF, 400V for universal input). On the S-60-12’s board, Manish found a chunky 100µF/400V capacitor. It stores energy between peaks, creating a flat(ish) high-voltage DC bus of about 170V (for 120V AC) or 340V (for 230V AC).
A small variable resistor (VR1, a 1kΩ trimpot) lets you adjust the output from ~10V to 14V. But the real hero is the programmable shunt regulator and an optocoupler (PC817). Manish found the chip near the optocoupler
The MOSFET’s source connects to a (a low-ohm, high-wattage resistor like 0.33Ω). This resistor tells the UC3842: “If too much current flows, shut down immediately.” It’s the overload protection.